All of the functions on the remote have equivalent commands in RS-232, Ethernet, and Wired IR formats. In
Power
Turns tuner on and off. Discrete on and off IR commands are
available as well.
Volume Control
Use the Vol+, Vol- and Mute buttons.
Channel Selection
The key change in digital tuning is the need to add a dash (-) and
number after the traditional channel number. Analog channels are
accessed using XX-0, digital channels using XX-1 (or -2, -3, etc).
Ch+, Ch- and PrevCh can be used to access and recall channels.
Menu Operation
Press Menu to access the on-screen menus.
Use the directional Arrows, Select and Exit to navigate the
menus.
List displays the list of all channels, arrow keys add/remove
channels, set Favorite Channel list
Exit steps backwards out of menus
Enter selects menu choice
Special Functions
CC steps through available closed-captioning options
Audio selects audio and SAP modes
Signal displays channel signal level
Ratio steps through aspect ratios, options depend on
channel and output types
Info launches on-screen information window
A/C selects Air or Cable tuning
Fav Displays list of favorite channels
Guide displays on-screen Guide
Features of many of the Special Function commands depend on
whether the current channel is analog or digital.
Tip: The output rules behave differently for digital and analog
channels. When you set up the tuner, use the RATIO button to set
image output for a digital channel, then tune to an analog channel
and set that to 16:9 or 4:3. The same rule applies to the
Menu/Setup/Screen Format menus. Set for analog and digital.
Comments to this Manuals