Contemporary Research QMOD-SDI Manual download pdf (Page 6)

Contemporary Research 6 QMOD-SDI 2

Common

This series of menus sets global values for QMOD operation. Grayed menus cannot be changed via Web page.

Channel

Sets the physical channel, 2-135

QAM Type

Selects QAM 64 or QAM 256 (default). Fixed at 256 when 2-channel mode is enabled.

Continuous Wave is often used to test the channel with a meter.

256 | 64 | CW

Cable format

Standard cable frequencies (default)

HRC – same as Standard, channels 5 and 6 slightly different

IRC – All channel frequencies are different than the standard cable setting

RF Level dB

Sets the RF level of the channel.

29 | 25 | 21 | 17 | 13 | 9

IP Mode

Selects Static (default) or DHCP IP modes

 DHCP will select new address, will switch to static if network not present

 IP Address will show change when you select DHCP

 If you go back to Static, the address you defined in that mode will be set

IP Address

192.168.1.231

Left/Right steps through each group, click Up or Down arrow to step one at a time, hold

down to move faster. Address also appears on LCD when QMOD restarts.

Gateway

255.255.255.000

Quad address – Left/Right steps through each group, click Up or Down arrow to step one

at a time, hold down to move faster.

Subnet Mask

255.255.255.0

Subnet has a limited range of combinations, so this function is simplified

Left/Right steps through each group, click Up or Down arrow for options

Telnet Port

2728 (default)

IP port for Telnet communication – Click or hold Up or Down to set.

Output Mode

Select outputs for stream, IP menus only appear when selected.

RF |IP|RF+IP

QMOD IP Port

Enter IP address for IPTV

UDP Mode

Selects UDP mode, sub menus change depending on mode

Unicast|Multicast

DstMultiAddr

Enter IP address for multicast

Dest IP Addr

Enter destination IP address for unicast

Dest IP Port

Enter UDP port for unicast or multicast

MAC/SN

Shows network MAC address

Ex: 00:04:9F:14:30:40 (last 2 bytes is the serial number)

LCD Contrast

Contrast 1-15

LCD Bright

Display brightness 1-16

Temperature

Internal temperature

Fan Speed

Set fan speed in percent

Backlight

Display brightness 1-10

CVCT

Activates inclusion of virtual channel ID and short Name in the video stream.

On (default) | Off

FW version

Firmware version

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments

Contemporary Research QMOD-SDI Manual Page 6

Comments to this Manuals

Related products and manuals for Modulator Contemporary Research QMOD-SDI